 |
 |
PU OPENEND TIMING BELTS |
PU JOINED TIMING BELTS |
 |
 |
NFT NYLON FABRIC ON TEETH |
PU HTD TIMING BELTS |
 |
|
| SPECIAL BACK BELTS |
|
Features and
Benefits
Welded Timing Belts are available
in virtually any length
Especially useful for conveying applications, welded timing belts
can be made to nearly any possible length with out requiring an
additional mold. Normal timing belts are only available in a limited
number of sizes and are generally not longer than 12 feet. Mectrol
welded timing belts have the strongest joint of any urethane timing
belt company. These welds are normally strong enough for the toughest
conveying applications.
Polyurethane
Body is ideal for timing belts being used a conveying belts
Polyurethane offers extremely
good abrasion resistance, much better than traditional neoprene
timing belts. Urethane also is resistant to most chemicals, water
and oil making it well suited for tough industrial applications.
Urethane is also an ideal material to work with for custom fabrication.
Surfaces can be ground to tight tolerances, profiles can easily
be thermally bonded, backings can be added and holes can be added.
Steel or KEVLAR?
Reinforcement
Both steel and KEVLAR? are ideal
cords for many conveying applications. They both offer very low
stretch which means that re-tensioning and other maintenance is
not required. They are also dimensionally very stable under a
wide variety of environmental conditions. Parts or products can
be positioned repeatably and reliably.
Linear Placement
of Cords
All cords in Mectrol's linear
belt are located in the belt parallel to the belt edges and exactly
perpendicular to the belt teeth. As opposed to belts that are
produced with a helically wound cord, these linear belts will
exert little or no side force making them much easier to track.
There are no exposed cords at the edge of the belt which can fray
and contaminate product.
Low Backlash
Proper selection of belt and pulleys
can result in low or zero backlash in the belt and pulley system.
Other Advantages
Positive Synchronization
No re-tensioning required
High operating speeds
No lubrication required
High accuracy in molded dimensions
|
